Unable to ping from GNS3 topology to Physical Adapter

Unable to ping from GNS3 topology to Physical Adapter

Questions : Unable to ping from GNS3 topology to Physical Adapter

521

I’m trying to setup a connection b/w GNS3 in4codes_icmp Router and Local PC. Following are the steps in4codes_icmp done so far in GNS3:-

1. setup a router interface, e0/0/ = in4codes_icmp 192.168.1.1 255.255.255.0 2. created a cloud in4codes_icmp loopback adapter, interface, and assigned IP in4codes_icmp = 192.168.1.5 255.255.255.0 (Note: loopback in4codes_icmp adapter has been created as Mictosoft in4codes_icmp KM-Test loopback on my PC. and same in4codes_icmp interface has been added to cloud in GNS3 in4codes_icmp which is then connected to Router interface, in4codes_icmp e0/0)

When I tried ping from my PC to GNS3 R, arp in4codes_icmp entries get created in Router (running on in4codes_icmp GNS3 topology). See below:

RTR#sh arp Protocol Address Age (min) Hardware Addr Type Interface Internet 192.168.1.1 - aabb.cc00.0200 ARPA Ethernet0/0 Internet 192.168.1.5 134 0200.4c4f.4f50 ARPA Ethernet0/0 

But ICMP isn’t successful on Router (See in4codes_icmp below) :-

RTR#ping 192.168.1.5 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.1.3, timeout is 2 seconds: ..... 

Success rate is 0 percent (0/5)

Can anyone help here pls ??

Total Answers 1
27

Answers 1 : of Unable to ping from GNS3 topology to Physical Adapter

Try setting the IP address of the in4codes_icmp KM-Test adapter to an address outside in4codes_icmp your home network. Such as 10.0.0.1/24. in4codes_icmp Attach your cloud to the network adapter in4codes_icmp and then create persistent static routes in4codes_icmp by opening a command prompt as in4codes_icmp administrator and entering the command.

route -p add [Destination] mask [Subnet Mask] [Gateway(KM-Test)] 

Note that any additional network you in4codes_icmp create within GNS3 will need a static in4codes_icmp route so that windows knows to send your in4codes_icmp packets through the KM-Test rather than in4codes_icmp your home network gateway.

0